Configuring an FCoE Storage Array with COMSTAR (Task Map)

Configuring an FCoE Storage Array With COMSTAR (Task Map)

This task map describes the tasks necessary to set up and configure a COMSTAR target in a Fibre Channel over Ethernet (FCoE) network environment, then make it accessible to the storage network. Ensure that your system meets the necessary prerequisites before you begin.

Task Description Instructions
1. Perform the basic setup steps listed in the Getting Started with COMSTAR section. Enable the STMF service, create SCSI logical units, and make the logical units available.
 How to Enable the STMF Service
How to Create SCSI Logical Units
How to Make SCSI Logical Units Available
2. Configure ports. Configure FCoE ports. How to Configure FCoE Ports
3. Make a logical unit available. Make a logical unit available to all hosts or specific hosts on a Fibre Channel or FCoE storage network. How to Make Logical Units Available for FC and FCoE

Labels

newuser newuser Delete
configuring configuring Delete
storage storage Delete
task task Delete
Enter labels to add to this page:
Please wait 
Looking for a label? Just start typing.

Sign up or Log in to add a comment or watch this page.


The individuals who post here are part of the extended Sun Microsystems community and they might not be employed or in any way formally affiliated with Sun Microsystems. The opinions expressed here are their own, are not necessarily reviewed in advance by anyone but the individual authors, and neither Sun nor any other party necessarily agrees with them.

Copyright 1994-2009 Sun Microsystems, Inc.
Powered by Atlassian Confluence Sun Guidelines on Public Discourse Privacy Policy Terms of Use Trademarks Site Map Employment Investor Relations Contact